Hawk Tuah Girl Meme Funny Shower Head

***PLEASE CLEAN YOUR BED PROPERLY BEFORE PRINTING. DAWN DISH SOAP(Or Equivalent) AND HOT WATER THEN DRY WITH PAPER TOWEL OR AIR DRY!! NOTHING ELSE NEEDED!! THIS WILL ENSURE YOUR PRINT IS SUCCESSFUL***

##  These models printed as shown but if you dont clean your bed properly and have adhesion issues, then you can add a brim or mouse ears. I test all my prints and it is proven to print as I set it up. ##

Just another idea i had to make this meme into a shower head, its been a tough project and is STILL BEING WORKED ON!! So there may be issues!

>>You will have to experiment with various O-rings, Teflon tape, and rubber washers to try to make it not leak<<

***Known issues*** that havent been resolved are mostly leaks. I have tied to add a few O-rings and Teflon taped the ball Joint but still seems to leak. Still trying to dial in a method to make it seal better. Perhaps more walls would help? if anyone wants to experiment and help trouble shoot. Open to suggestions to make it work properly.

***Another issue*** is I have yet to get the water to come out in a spray pattern with the size of the mouth I have angled the hole as much as possible but still doesnt separate the streams like i wanted.

I have the print laid out on 2 plates with plate 2 being locked to print per object to try to make the threads come out better, you may have to trim some strings away after they print. Most of you may want to use a brim on those. I have the new Cryogrip plates so didnt need a brim.

The head is oriented the best way i found to keep threads clean and make supports easier to remove around tiny things like the earrings( use your cutting tool to gently trim away the tree supports.. I use my cutter and cut at parts where the supports meet the model and it seems to help separate them easier. (see image below)

This was just a fun idea i had and wanted to share so experiment and see if you can make it work.