Exclusive Hawk Tuah Meme Threaded Beer Tap Handle

***PLEASE CLEAN YOUR BED PROPERLY BEFORE PRINTING. DAWN DISH SOAP(Or Equivalent) AND HOT WATER THEN DRY WITH PAPER TOWEL OR AIR DRY!! NOTHING ELSE NEEDED!! THIS WILL ENSURE YOUR PRINT IS SUCCESSFUL***

##  These models printed as shown but if you dont clean your bed properly and have adhesion issues, then you can add a brim or mouse ears. I test all my prints and it is proven to print as I set it up. ##

Decided to make a Hawk Tuah girl Tap handle it is threaded to fit common tap sizes by screwing it on. My hawk tuah sprayer went viral so i figured some people may want this as well.

My print settings ARE HIGHLY RECOMMENDED and were beefed up around the bottom so it would have some extra strength where needed.

Settings: .20 layers with 8% adaptive cubic with infill combination checked, for the most part. but I added modifiers with custom settings under “objects” to make strength adjustments where needed.

Support: Tree(auto) > Tree hybrid > support critical regions only(checked)

Be very careful around the ear rings as they are fragile, I use my snips to carefully cut around them and release them(id you happen to break one you can usually glue it back and it will look fine) as seen in image below if you place your cutters at the line where support meets model it will usually force it to separate pretty easily.

Have fun with it, Cheers!