Search models, users, collections, and posts
LX470 and LC100 Liftgate Flag Carrier
IP Report
Print Profile(2)
0.6mm nozzle, 0.3mm layer, 4 walls, 100% infill
Designer
1.5 h
1 plate
ABS, Top Surface ironed, less supports, chamfered, mirrored
4.8 h
1 plate
Open in Bambu Studio
Boost
12
45
5
1
24
13
Released
Description
This was a quick model I whipped up to hold a can am standard flag for driving out in the sand dunes safely. I tested this in Pismo Beach, California and it held up well. On top of that, if you manage to break it, you can cheaply print a few spares as backup. It bolts into the tailgate bump stop bolt holes.
Orient the print so that the layer lines are perpendicular to the stress the flag will take bouncing up and down.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)