Search models, users, collections, and posts
PUERTO RICO Flag Clock
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.5 h
1 plate
Open in Bambu Studio
Boost
49
90
20
6
61
31
Released
Description
Puerto Rico Clock
This clock is approximately 228mm in diameter.
Almost any clock mechanism should work as long as the threaded shaft is 8-10mm long at a minimum and less then 60mm square. I purchase my clock mechanisms on AliExpress.
Visit https://makerworld.com/en/@railimages to see my other clocks and coasters
This profile worked fine for me on my X1C, but you may find some profile settings that will work better for you.
Boost Me (for free)
I would appreciate it if you could rate my model and profile and I would greatly appreciate it if you could maybe even do a BOOST if you really like it,
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (20)