Search models, users, collections, and posts
Foregrip Mag Carrier Release Lever/Switch
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
18 min
1 plate
Open in Bambu Studio
Boost
10
21
0
0
9
4
Released
Bill of Materials
Maker's Supply Kits and Parts
Select all
Description
Didn't do much but adapt it for polycarbonate filament. The filament I used was actually PC-CF. This was printed on an X1C in vertical position. No supports needed. Just had to remove the brim. I originally printed this in PETG and when I put the spring and pins in it broke, so I went with a stiffer and stronger material. I plan on printing the rest of the foregrip still in PETG or ASA since they are much cheaper filaments and still acceptable for wear, heat resistance, and strength.
FYI I used 1mm thick by 10mm diameter by 20mm long uncompressed spring. The Bambu .6x8mmx20mm spring would probably work well too.
Comment & Rating (0)