Knurled DynaVap Container for Most DynaVap Sizes

My take at a small and rugged container for my DynaVap. I really like the texture of the knurling, and the threads are really smooth so it doubles as a pretty good fidget toy.

If your tolerances are off, it might be helpful to scale the part up or down in small amounts using your slicer.

There are a ton of different DynaVap models out there, but from what I can tell they all fit into one of four sizes.

Never put a hot DynaVap into any 3d printed container.

The standard "M" size

This includes most "M" models and the non-XL OmniVap. Fits max height of 92mm.

The OmniVap XL size

Same width as the "M" size, but a little bit taller. This mostly applies just to the OmniVap XL, but could also apply to "M" models with a mouthpiece. Fits max height of 109mm.

The VonG

The VonG shares the same height as the M, but is wider to accommodate the wooden midsection.

The VonG XL

Same width as the VonG and same height as OmniVap XL. This will fit VonG XLS models, but probably not XL models with an added mouthpiece.

Notes:

This print should be pretty forgiving with whatever settings you throw at it. I was successful with layer heights between 0.15 and 0.3. PETG is recommended if you're handling a hot dynavap, but if you let it cool before putting it in this container then you should be good with PLA.

About reselling this model:

If you decide to sell prints of this model, please leave credit of some kind in the description. My goal is to make sure it's clear that the model is available to download for free.