Peely Pick Fortnite Pickaxe Prop - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

xkingpin

Props & Cosplays>Cosplay Weapons

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.16mm layer, 3 walls, 5-15% infill

Designer

35.9 h

5 plates

4.6(5)

Open in Bambu Studio

Boost

117

212

194

Released

Description

I colored and setup a good print profile for the Peely Pickaxe by rubaxx. This will work on the A1 Mini as well if you reorganize the plate. I might upload that profile as well.

This model uses 8 parts. It will need a 5mm rod with 70cm and 2 other rods of 5mm at 20cm. This will give it more structure. You could also just try to some kind of super glue to hold it together.

A great Halloween prop for the Fortnite costumes out there.

Comment & Rating (6)

@BeccaKris

Print Profile

0.16mm layer, 3 walls, 5-15% infill

Super cool file. The design for the peeled back banana pieces is super hard to attach. Small and thin it took many attempts to get it on right. Had to super glue, 3d gloop, then try and heat weld it together which worked for the thicker side pieces but the thin top one just so thin it keeps breaking off. Used automtive primer-filler spray paint to help too and didn't work like it normally does to fill the smaller spaces and help make thinner pieces stronger. If there is a better way to cut those banana peel pieces to have a better spot to bond together, it would greatly improve this print. I am making it work because it is such a cool print. Trying to get the to piece back and on and finish painting for halloween