Search models, users, collections, and posts

Case for Oral B Pulsonic Slim toothbrush

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini
H2D
H2D Pro
H2S
P2S
H2C
X2D
A2L

0.24mm layer, 2 walls, 15% infill
0.24mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
4.3(15)

Open in Bambu Studio
Boost
21
86
19
5
163
109
Released 

Description

Content has been automatically translated.
Show original

A simple yet sturdy travel case for an Oral B Pulsonic Slim toothbrush. Easy to close with a large screw cap. Both tubes have a hole in the head so that excess water can drain.

Comment & Rating (19)

(0/1000)

Print Profile
0.24mm layer, 2 walls, 15% infill
The case was printed without any problems using the PLA Generic settings. Unfortunately, the inner diameter is almost 2.5 mm too small and therefore not usable with an Oral-B Pulsonic Slim.
The profile uploader has replied
Show original
0
Reply
Hello Jonas, thank you for your feedback. I believe what you have is not a Pulsonic Slim but rather looks like the IO series. It is thicker. The Pulsonic Slim fits perfectly in the case for both me and my wife, and does not rattle back and forth during transport.
Show original
0
Reply
Replying to @Utz73 :
No, it should be the Pulsonic Slim Clean 2000… unfortunately, it doesn't say that anywhere precisely. It's not an IO
Show original
0
Reply
Oral-B Pulsonic Slim Clean 2000 does not fit in. All that time, energy and filament wasted. 5 Cent (Euro) fits well and loosely.
(Edited)
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Worked out just fine! Printed wuth 10% flash infill. Could be even smaller for my brush as I have the 'old' version which is even more slim.
0
Reply
Boosted
Print Profile
0.24mm layer, 2 walls, 15% infill
Passt perfekt
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
After screwing together it's not quite centered. But close enough.
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
1. print is broken right at the thread… fell out from 60cm with PLA. 2. print then with PETG, the thing holds, great for my travels
Show original
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
My sister uses it regularly and is thrilled with it
Show original
0
Reply
The thread initially binds severely After some back and forth turning and a bit of wear it eventually works
Show original
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Thumbs up… fits perfectly and the size is also great
Show original
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Superb idea and execution, complemented by a fine print A tad lengthy, but this doesn't detract from its usability
Show original
0
Reply