Asus rog ally stand
Remixed by
Copyright Claim
Asus rog ally stand
Remixed by
Boost
29
54
43
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
0.2mm layer, 2 walls, 15% infill
7.2 h
1 plate
0.2mm layer, 3 walls, 15% infill
3.2 h
1 plate
Boost
29
54
43
13
268
224
Released
Description
very simple stand for the rog ally,prints fine on PEI plate the included print profile shows the infill patter, increase that if you dont like it!
Comment & Rating (43)
All
Boosted
Def a nice stand and I want it to hold the functionality for docking as well So been working on a dock-able version of this for my use. Meanwhile here is my test print and color. The base is black for obvious reasons and I went with gold for the ROG logo. I want that logo to RGB like the analogs so I am working on incorporating that into my dock version. The dock version will also run the full length of the screen so will be a bigger print than this original as well. Been in blender tinkering away at this when I have time to do so. Best dock creation I have seen so far.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fit great, super clean print though I can't use silicon case I have, but reasonable
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
matte black embroidered
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Super
0
Reply
Thanks. Came out good
0
Reply
Love it, Just what i needed
0
Reply
Boosted
super clean print, thank you.
0
Reply
Boosted
Thanks for your Design. it Inspired me to my first upload here
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
will have to adjust for any accessories on your ally
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
my new favorite stand for my ally
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld