DryPod for AMS - insert turned 30 degrees to align moisture meter Remixed by Achimque

Remixed by

Achimque

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 6 walls, 25% infill

2.6 h

1 plate

4.8(38)

Boost

282

160

Released

Description

I had in issue with wrong oriented moisture meter, so I turned the notches 30° to align it correct.

On some Slicers the part gets 10 times bigger. Could not find out the reason. Simply scale it to 10% to make it fit

Comment & Rating (47)

@Fredrik88

Print Profile

0.2mm layer, 6 walls, 25% infill

I added a small subtract cube to get underneath the meter to replace batteries

@Fredrik88

Replying to @LongracksLabs :

I just added a modifier in the slicer, but I have PMed you the file =)

@Hony684

Print Profile

0.2mm layer, 6 walls, 25% infill

good

@KiCkiN

Print Profile

0.2mm layer, 6 walls, 25% infill

Printed perfectly.

@user_570132757

nice offsite it turns out to be great and I printed it with PETG. A Bambu translucent filament.

(Edited)

@BS3DPrint

Print Profile

0.2mm layer, 6 walls, 25% infill

Genial, el higrómetro encaja perfectamente

@BlueKiwi

Print Profile

0.2mm layer, 6 walls, 25% infill

👌

@brown.kyle.c

I would love to see a version that is an assembly. so the inner notches can be rotated as needed. I believe mine is 45° as well.

The designer has replied

@jimtng

What would be even better if it is rotatable after being printed, so it would work for any orientation.

@Achimque

Replying to @jimtng :

I uploaded a version without notches, so the meter can be rotated freely

@VitaminJTX

Print Profile

0.2mm layer, 6 walls, 25% infill

this was an awesome remix for the hygrometer that I purchased. My AMS is at a consistent 10% humidity.

The designer has replied

@LongracksLabs

thats great! FYI I am not sure i'd trust it as an 'absolute' 10% reading for the AMS since hygrometer is basically embedded in the desiccant beads. I use it as a relative reading to tell when I need to look to refresh / replace the beads. So if it is 10% 'fresh', when it gets to about 30% i check the color and replace/refresh.