Clear as glass PETG

This is a sample model to share settings for printing extremely clear PETG!

This is NOT optimized or tested with PLA. Do not print this with clear PLA and expect the same result!

🚨 New model drop: Fold-n-Seal Bag Clips 🚨 

Pop quiz! What do people love almost as much as crystal clear PETG? Perfectly sealed chip/food bags!

Get it 👉 https://makerworld.com/en/models/1614897 

Ok back to the clear as glass PETG notes….

You must use a smooth plate! Textured plate will not give you transparent bottom layer. The best results I found were when using the clear holographic plates I have. The Bambu smooth PEI plate left a semi-frosted bottom layer, so it was not ideal.

To get very clear prints, the most important thing is that it is printed very slowly, small layer height and the exact same pattern on each layer at 100% infill.

this works well with simple objects, less so with complex ones.

You can likely minimize lines even further by playing with the extrusion rate in the filament profile.

To apply this to your own models:

• Edit the 0.1mm fully transparent petg project profile (the save button) and resave as a user preset (with a new name)
   

  

• Do the same for the SLOW PETG Translucent filament profile with a new name and select User Preset. 
   
• 

Now you can use these again for other prints. Just remember, depending on what you are trying to print, it will need to have the exact same pattern on each layer at 100% infill.

Also, If you would like to sell physical prints of my standard license models only, you can join my Patreon here. This license does not allow selling or distributing the digital files, and your membership must remain active while you sell physical prints.

https://www.patreon.com/WowForge