Search models, users, collections, and posts
GYM - SQUAT MAN FIGURE / TROPHY
IP Report
Print Profile(2)
SQUAT MAN
Designer
8.7 h
4 plates
0.16mm layer, 3 walls, 12% infill
11.4 h
5 plates
Open in Bambu Studio
Boost
384
844
38
25
574
236
Released
Description
SQUAT MAN FIGURE
Instruction:
- Print Plate n.1;
- Remove Support;
- Print Plate n.3;
- Stick the Squatman on the base with glue;
- Print Plate n.2;
- Stick the disk in couple back to back;
- Print Plate n.4;
- Stick “stop” on the disk and stick all to the bar;
- The distance from the stop to the end of the bar will be the same of the opposite side;
- Insert the bar through first hand, pass behind the neck, in the appropriate location, in the end insert the bar in the another hand;
- Stick “stop” on another disk couple;
- Stick all on the bar leaving the same distance left before on the other side.
P.S.: In photo the base is signed “essenza”, in model the base is blank.
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (38)