Print Profile(0)
Description
There are two models to make one small print: a full coverage screen protector surface and an infill modifier blank. The idea is to center the modifier in the screen protector and change the top and bottom shell layers to zero. Once that is done you can pick any infill pattern and percentage to get a custom effect.
Obviously, as far as practicality, anything over the screen will stop touchscreen functionality. So maybe this won't be actually useful for you. That said, if you don't need to touch the screen this may be a good protection layer for the face of the watch. Depending on the infill pattern you choose it might serve to enhance screen privacy a little too.
The screen protector model is sized at 99% of the AWU body for an intentional snug fit. For me in PLA+ this requires a firm press down on all four corners at the same time. If the fit doesn't work for you, adjusting the scale very slightly may improve results.
For the print here, I used 15% gyroid infill.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)