Dummy 13 - Mando Mandalorian Bulky Muscular

Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

Based on three Remixes at 100% Scale. Wanted a bulkier version of the Mandalorian for Dummy 13 Version 1.0. Wanted bigger arms and legs.

Follow these prints: 3 Prints Total.

• Print Dummy Version 1.0 Skeleton - On Runners would be much easier by Lucky 13 Toys at https://makerworld.com/en/models/638587#profileId-564186. It is easier to assemble than the original.

   

• Print Dummy 13 Mandalorian Outfit Kit Card by milkyway at https://makerworld.com/en/models/550250#profileId-468615 for the Mandalorian Armor/Outfit and Gear

   

• Print the rest here. It is a combination of the Dummy 13 Version 1.0 and and the bulky dummy 13 at https://makerworld.com/en/models/604149#profileId-527267

  - Only 2 new skeletons are needed: One for the head of the Mandalorian Outfit Kit which was based on the original version, and the other is for the shoulders/clavicles extended version from the Bulky Dummy 13.

  - The rest of the armor I subtracted or added as necessary based on the armor from the Dummy 13, Mandalorian Kit Card and Bulky Dummy 13. I did not use the chest and thighs from the Mandalorian Kit, but instead used from the Bulky Version. Just my preference. I wanted a stockier version. Just split the plate to color individual parts as I did to make it look more like the Mandalorian. 

Note: The mask is one color. I just manually colored it. A sharpie touchup.

Follow the Dummy 13 version 1.0 Assembly Guide. Except swap the head skeleton insert in Diagram 1 and the Clavicles in Diagram 21 from this print.

ASSEMBLY

Follow these steps to assemble Dummy 13. 

More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - https://makerworld.com/en/@3djd/collections