Search models, users, collections, and posts
Makita DC18SD charger wall mount
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 100% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
355
1112
127
57
2.2 k
1.6 k
Released
Description
This is a remix of a simple mount for the newer Makita chargers, which I found excellent but not suitable for the older models. I have adapted the location of the pegs/plugs to align with the DC18SD feet.
As per the original instructions, just remove the four rubber feet and press the charger down onto the pegs on the mount, simple as that.
Can be mounted in all directions due to being press fit.
Reports of being a tight fit, might be due to using PETG instead of PLA. Recommend PLA for this design.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (127)