I like this
I use a GoPro with my diving, so I printed in orange PETG and added a 4mm hole so I can add some bungee so I can tether my camera for some added security
glued in some marine grade M5x25 hex screws

The knob is short though and is unsuitable for use with the GoPro underwater housing

AussieDiver

0.2mm layer, 3 walls, 25% infill

OfficinaLayer

Horus_Eye

Minniprof

FoerdePrint

Henk

knartz

qulix

MoreVolts

Duvi.d

 ne avevo veramente bisogno: un’idea geniale!

Nicolò

NiedzielnyMaker

cover

plate_1.png

SpaceBison

IMG_20241122_121506.jpg

IMG_20241122_122129.jpg

No supports. The round hole is a bit tight and needed some treatment with a 5mm drill to let the screw pass through. Other than that, it printed really nice. I really like how compact the smallest ones are.I heated the screw heads with a lighter before insertion to make they stick and don't come out.

IMG_20241123_104128.jpg

Printed with PETG. I was trying to get the print as transparent as possible, it didn't really work, but I like the result either way. There was no need to widen the hole, I pulled the screw in using a nut without heating and it sits nicely.

0.1mm layer, 0 walls, 100% infill

IMG_0880.jpeg

IMG_0882.jpeg

vertically scaled to 55.4mm to allow screwing under/besides the camera. Its a bit hard to keep the screw centered while inserting… I used a small screwdriver to recenter the screw from below, while pushing with a bigger screw driver from above.

Long Version - 0.2mm layer, 3 walls, 25% infill PLA

GoPro Knob M5 hexagon bolt or screw

ASIA

Print Profile(3)

Description

Comment & Rating (64)

License

Related Models