Search models, users, collections, and posts
Spunding Valve Gasket for BrewBuilt 1.5 triclamp
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
1
7
0
0
4
0
Released
Description
My gasket on the spunding valve had a rip so I took the time to design a new one in tinkercad. After a few iterations and some TPU I found a great fit. Stood for 2 days in a bowl and never leaked. This only holds water and never actually touches the liquid inside the fermenter so no worries about food safety on the TPU but I would NOT recommend printing with non-flexible filament. This was only tested with 95 shore TPU filament so print at your own risk with other materials. Keg lube highly recommended for a snug fit.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)