P1S / P2S build plate side holder V4.5 / 5.5(new)
Print Profile(3)
Description
This is a build plate holder that hangs off the side of a P1S/P2S.
I made it open ended so that it can be mounted on either side.
It can hold up to 4 plates. These slightly wider slots accommodate aftermarket plates.
I made a cut out in the middle strictly to save on material. This does not require support.
I removed the old print profiles and reuploaded new profiles with brims to help address print failures.
Version 4.5 is 8.00 inches(20.32cm) wide and has room for 4 plates.
Version 5.5a is 6.00 inches(15.24cm) wide and has room for 4 plates.
Version 5.5b is 6.00 inches(15.24cm) wide and has room for 5 plates.
NO SUPPORT NEEDED FOR ANY OF THE PRINT PROFILES IN THEIR CURRENT OREINTAION.
I have a closed end reversible design here.
https://makerworld.com/en/models/988736#profileId-963906
Here is my offset model with room for 4 build plates:
https://makerworld.com/en/models/2561289-p1s-p2s-build-plate-holder-offset#profileId-2822106
Boost Me (for free)
A boost would be greatly appreciated!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (262)