Material Standoff for Laser Cutters - Free 3D Print Model

Search models, users, collections, and posts

Gianni9300

Tools>Machine Tools

IP Report

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

56 min

1 plate

4.2(13)

0.16mm layer, 2 walls, 15% infill

1.3 h

1 plate

5.0(7)

Open in Bambu Studio

Boost

210

316

180

Released

Bill of Materials

List other parts

32x2mm round magnet x 1: Available everywhere

Description

This standoff will fit any laser with a steel Honeycomb bed.
It keeps your material 10mm (3/8") above the bed to reduce flashback.
Adjustable for material thickness of up to 16mm (5/8").
Magnet up to 32mm x 2mm thick, sits in bottom piece to keep standoff from moving.
Magnets readily available on Amazon.

laser accessory

material stanadoff

laser material standoff

Comment & Rating (28)

@Ashmo5224

Print Profile

0.16mm layer, 2 walls, 15% infill

first I printed the main file and I couldn’t screw the pieces together so I reprinted it with this profile and it worked perfectly!

@EktoRod

Good file but needed just a little tweaking to make it a better model. I separated the objects and increase the top screw lock piece to 101% and then i decreased the magnet screw piece to 99%

@alan.kreifels

Print Profile

0.2mm layer, 2 walls, 15% infill

great design. I bumped up the finish with a .16 quality layer & split the stl into objects. I set the top nut x-y hole compensation to .1mm and the bottom magnet holder to -.1mm x-y contour compensation and threads worked effortlessly on my P1S.

@MetaImi

Print Profile

0.2mm layer, 2 walls, 15% infill

Other Issues:it is a bit hard to screw together the bottom part and the item.

@quentinroger

Print Profile

0.2mm layer, 2 walls, 15% infill

top

The profile uploader has replied

@Gianni9300

Thanks for the rating !

@user_969879779

Print Profile

0.2mm layer, 2 walls, 15% infill

can hardly screw them together. threads are to tight

The profile uploader has replied

@Gianni9300

I tried different threading, but this was the best result. I loosened the threads by going back and forth 1/4 turn a few times, then screwing further and repeating. It takes a few minutes, but it ends up working.

@robertgb

Print Profile

0.2mm layer, 2 walls, 15% infill

It’s hard to assemble, I don’t think you took into account the material tolerances. While the print looks good, the fact that it's unusable like this and I have to throw it away says it all

Show original

@GenericBeard

Very helpful to the laser workflow! Threads were tight as some other users have mentioned, but after running them on and off a few times they actually feel pretty good. I'd rather have them a little tight than a little loose.