Maker Dave

cover

1000001171.jpg

1000001172.jpg

1000001173.jpg

1000001215.jpg

plate_1.png

1000001171.webp

I printed at .2 with just supports under the beak. I colored the model as I think was appropriate. If you have the time you could do all the feathers. This prints in about 3 ½ hours with just the 3 colors.

0.2mm layer, 2 walls, 15% infill

aishunbao

PXL_20241128_115411081.jpg

PXL_20241128_115256005.jpg

I liked the Creator's napkin holder, but I was concerned about the staircasing and the huge amount of poop waste from the original print profile, plus I wanted to create just one napkin holder for the whole table. I printed this on generic brand Matte Terracotta Red PLA and it turned out great!&nbsp;&nbsp;These were the major changes:<ul><li>0.08 mm and variable layer heights to greatly reduce staircasing that came with the organic shape</li><li>Single color to eliminate filament changes and poop waste</li><li>450% scale (from the original 239%) to be used as a single napkin holder for the table and for typical square 6.5x6.5" napkins in bulk packs</li><li>Enabled slim tree supports for the beak and wattle</li></ul>Not sure if the brims were needed but I trusted the Creator's reasoning on this one.&nbsp;

0.08mm/variable layer, single color, 450% scale

My wife wanted a festive napkin holder for thanksgiving. I used Tinkercad and created this Turkey napkin holder and then had to figure out the scaling. I ended up scaling my original design about 239% to get a size that she thought was good.

Thanksgiving Turkey Napkin Holder

ASIA

Print Profile(2)

Description

Comment & Rating (35)

License

Related Models