Search models, users, collections, and posts
HGR15 Linear Rail End Stop
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
33 min
1 plate
Open in Bambu Studio
Boost
7
12
4
1
32
17
Released
Bill of Materials
List other parts
- Insert x 2: M3brass
- Setscrew x 2: M3x(6-10mm)
Description
End stop for HGR15 rails. Designed to stop the material support arms from coming off of my Langmuir Systems Titan 25T CNC press brake. Will work on any other HGR15 rails as well. Uses up to 2x brass M3 heat set inserts per end stop for redundancy or situations where you want it more tightly locked onto the rail (for approx 4.2mm diameter and 6mm deep insert). Install inserts from inside part (side that faces the rail) not outside, that will make the inserts much less likely to push out or split the part over time.
Original part printed in ABS-GF, but should work in PETG or PLA depending on what filament you have around.
Parts needed for each end stop:
1 - Printed Part
1 or 2 - M3 Brass heat set inserts
1 or 2 - M3 set screws 6-10mm long
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)