Abaco 10x10

Easy to print abacus

Parts

• Legs: The abacus should have 2 main legs
• Supports: There are two supports for each leg.
• Balls: You will have to print about 102 balls, if you can use different filaments to make it more colorful and use less filament of a single color.
• Decorative: If you want, you can print some decorations to make it look better, these do not consume much filament.
• Sticks: You can print them or find them made of wood, their dimensions are: large= 27'5cm long and 4'3/4'5mm in diameter and the small= 22'5 cm long and 4'3/4'5 mm in diameter. You will only need one of the large sticks and ten of the small ones.

INSTRUCTIONS:

1. Place balls on the sticks
2. Place decorations before the balls

      3. Glue the sticks into the holes in the legs

      4. And then with the other leg

    5. And lastly put the leg supports

For more support, you can find this model on my Printables profile: https://www.printables.com/model/1030299-abaco-10x10

Thank you very much and I hope you like it.