Search models, users, collections, and posts
MTG Card Deck Box
IP Report
Print Profile(6)
0.2mm layer, 2 walls, 15% infill 1 plate
2.5 h
1 plate
Dbl Sleeved Deck + Tokens 3 walls, 1mm bottom
2.3 h
1 plate
0.12mm(less visible layerlines), 3 walls(faster than infill)
3 h
1 plate
Good for dragon shield standard outer 60 card deck
2.8 h
1 plate
Click to see more
Open in Bambu Studio
Boost
1752
5447
698
455
10.8 k
7.8 k
Released
Description
This is an easy to print and strong deck box that fits 100+ sleeved cards. Made for Magic The Gathering commander decks but these could easily be used for anything else. Print each half in different colours to mix and match designs.
The lids click into place and a full deck box can be held upside down without coming apart or cards rattling around inside. They are easiest to open by gently pulling apart one side and then opening all the way.
Print each half flat side (top or bottom) down and no supports are needed. Examples in the picture are printed with a variety of filaments with a 0.2mm layer height.
If you like this model, consider buying me a coffee: https://coff.ee/iansmithbuilds
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (26)
Click to see more
Comment & Rating (698)