Fox Proframe GoPro Chin Mount
Print Profile(2)
Description
Enjoy your GoPro with this new chin mount solution for your Fox Proframe helmet. The GoPro can easily be dismounted from the helmet juste by moving the camera forward and sliding the clips' base.
I tested it on big jumps and rough DH terrain and it doesn't move. As the camera is slightly under the helmet's base, it ensure that the camera will not slide out.
I design the model so that the parts are printed to be as strong as possible.
I have printed this model in PLA and it works well. However, PLA deforms easily at temperatures above 45 degrees Celsius. So do not leave it in the car in summer or print it in ASA or PETG.
NOTE: There are 3 "clips" that should be slid into the base of the clips. Each one must be mounted in its place.
Right: the one with the bolt's reservation
Middle: the flat one that's "thicker".
Left: the flat one that's "thinner".
Once the clips have been mounted on the base, lightly sand the base with sandpaper. There should be a reasonable amount of resistance between the clips' base and the chin mount.
Complementary material
2x Cable zip ties 203x3.6mm
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (41)