Dummy 13 - Bulwark of Azzinoth

UPDATE: (2025.01.24)
I’ve updated the model a bit in terms of support, with a "custom" minimal support that prints without any issues using the attached profile. I printed it with a 0.2 layer height, but the quality can be improved on the spikes if printed at 0.16 or 0.12. Minimal post-processing might be needed on the bottom part, but for me, it came off quite cleanly, so I only had to do a little touch-up.
 

Model Name: Dummy 13 - Bulwark of Azzinoth
Description: The Bulwark of Azzinoth, once the breastplate of the demon Azzinoth, is a massive and iconic shield, favored by tanks in World of Warcraft.
"Be careful with the spikes—they're really sharp!"

Since the shield is quite large, it can be attached using only a wrist without the need for a handgrip. I tried using a handle solution, but it wasn't very stable or easy to adjust. 
I used the original “frame, hip, and shoulder” joints, which need to be glued onto the designated spot on the shield. The joint should be positioned horizontally. I also cut a hole in the shield for the joint to fit, which can be glued in place if it's not tight enough.
And yes, it can also be secured on the back :D. 

If you like it, please consider supporting me with a one-time donation.