Iron-Nator
Print Profile(1)
Description
Hello, it’s that time again! I had some time, boredom, and motivation. :-) I found the model and thought it was so good that I made my own version! Just take a look at the result that came from my thoughts. :-)
The following parts are required:
( Countersunk screws M3x10, 6 pieces )
( Melt nuts M3x5.7, 6 pieces )
(Fairy lights )
( Red Led )
( Iron Man Eyes )
For the string lights, the upper part needs to be cut off; the LEDs are not needed. It’s best to cut it where the wire starts! If you want to use the remote control, you must modify the string lights as shown in the description. If you’re not comfortable doing that, no problem; you can also use the string lights without the remote control and simply press the white button on the bottom to turn them on. By pressing it multiple times, you can change the mode!
Important: The LED lens must be printed from colorless filament! The lens is not necessarily required; I included it because the light from the red LED was very bright. The lens slightly dims it!
Finished! Have fun with the model. If you have any questions, feel free to write! I would appreciate a good review, and of course, a boost as well. :-)
https://vm.tiktok.com/ZGdJyofnq/
https://www.instagram.com/reel/DAwH2CytEHb/?igsh=aTRkcGdwdW43MmRy
>
Boost Me (for free)
I exclusively develop unique models that I print and optimize multiple times until they fit perfectly and meet my quality standards one hundred percent. I invest many hours of work and a lot of filament to provide you with the best quality models. With a boost, you appreciate my work and give me the opportunity to earn points to finance my future projects.
This remix is based on
License
Comment & Rating (21)