Search models, users, collections, and posts
Google Wifi 1st generation wall mount
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
2 h
1 plate
Open in Bambu Studio
Boost
60
255
46
32
557
442
Released
Description
Original model made by aalcock @ Thingiverse: https://www.thingiverse.com/aalcock/designs
For 1st gen Google WiFi “pucks” only, the original creator (link above) made a great install instruction picture, but in short:
- install at the desired location with tape or screws
- seat the puck's cable exit side to the 2 smaller tabs
- click the other side of the puck under the lip of the big tab
Added two holes to the model for screw mounting, but can still be attached with a double sided tape, powerstrips, velcro strips etc.
3 walls and 25% 3D honeycomb infill for some rigidity, roughly 10 grams more with 100% infill. Supports for overhangs, check that these are on.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (46)