Sushi Soy Fish (Lamp) - Free 3D Print Model

Search models, users, collections, and posts

Mig86

Household>Decor

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.12mm layer, 5 walls, 15% infill

Designer

13 h

2 plates

4.7(21)

Open in Bambu Studio

Boost

240

691

470

212

Released

Description

This is a scaled up model of a Sushi Fish Soy Sauce container.

Intended to be printed standing on it's nose, without supports, scaled for a Bambu X1C.
The thickness is around 2mm.

There are two cap models included. One is plain, the other has some holes that I used to mount a DC barrel jack and LED's. You may have to adjust this to suit your electronics parts.

Comment & Rating (35)

@user_3824741821

Help out some clueless ladies, pls. 🤦🏻‍♀️ My friend and I printed ourselves a fish each, they turned out spectacularly 👌🏻👌🏻 BUT what the heck is a DC barrel jack & LEDs. In this case, Google is not my friend, it just confused me further. 🙈 In laymen’s terms, how does one get light into their fish? 🙏🏻😂😬

@user_1684345273

the led is the 'light bulb' and the dc barrel jack is what is needed to get electricity from outside to light up the led. i think it might be possible to buy those small usb light and add it to the bottom or other wireless lights and put it inside the lamp to light it up

@Enlighten3d

cool model, unfortunately did not work for me when using the profile in the Bambu maker app. failed at about 50%. using generic, but good quality white PLA. ordering some transparent PETG and will try again.

@penelopeanne

Have an A1 mini, so downloaded and resized the file to fit. Went with 70% and the vase setting with a brim. There is a slight opening at the tail but I believe that is because I probably should have made it a tad smaller to fit the printer. Very happy with the result. Added some cord through the cap to be able to hang it up.

(Edited)

@robertwesche

Print Profile

0.12mm layer, 5 walls, 15% infill

printed nicely on my H2D with clear PETG and fuzzy skin.

@Kinny_K

Going to make some string lights ...

@alexdenton

Boosted

Print Profile

0.12mm layer, 5 walls, 15% infill

Paused mid-print of the fish to put the Bambu light kit inside, and printed the cap in two parts since the USB connector and switch are too big to fit through the normal cap