Sigil
Print Profile(1)
Description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.3mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Silver Transmission Distance: 0.5
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Orange Transmission Distance: 5
This print uses 6 unique filaments. Substitute as needed.
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Blue Gray
At layer #11 (0.96mm) swap to Silver
At layer #13 (1.12mm) swap to Jade White
At layer #16 (1.36mm) swap to Black
At layer #17 (1.44mm) swap to Red
At layer #21 (1.76mm) swap to Orange
At layer #22 (1.84mm) swap to Jade White for the rest.
Boost Me (for free)
Got a Boost to spare? Every little bit helps the motivation. Thank you!
Membership
Want to go commercial or maybe just show some love? Consider signing up to show support!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)