8 mm - Shelf-Pin Offset Snap (DS Part A)

32mm & 5mm Shelf-Pin Offset Snap

The Shelf-Pin Offset Snap creates an 8mm gap between your Multiboard and a surface, compatible with the standard 32mm spacing and 5mm deep shelf-pin holes commonly found in cabinetry.

This versatile piece fits onto the corners of your Multiboard, integrating smoothly into systems using the “off-a-surface” mounting setup.

There are plates with various pin configurations shifted from the center point of the snap:

• 0mm
• 1mm
• 2mm
• 3mm
• 4mm
• 5mm
• 6mm
• 7mm
• 8mm
• 9mm
• 10mm
• 11mm
• 12mm
• 13mm

This allows you to match up mounting points in the 25x25 gridfinity grid with the 32mm spacing of shelf-pin holes. For offsets greater than 13mm, you can likely flip the part and use a different shelf-pin hole with a different shift amount.

You can secure the snap to the shelf-pin holes by inserting into shelf pin holes directly, without the need for screws. This is typically used for light-weight mounting solutions and IS NOT RECOMMENDED to bear significant amounts of weight.

As a “Double Sided Part A” snap, it can be joined with the Double Sided Snap - Part B for a secure connection. When joining these pieces, ensure the alignment of the square symbols.

To learn more about this component, visit: Multiboard Knowledge Hub.

Printing Guidelines:

• The printing orientation is pre-configured in the file for optimal results.
• Print with 3 wall perimeters for sufficient wall thickness.
• Recommended layer height: 0.2mm.
• Supports are required for the shelf pin of this print.
• Use 15% infill for structural integrity.
• This part features a tolerance of 0.25mm.
• Ensure your printer can bridge gaps of up to 30mm for successful prints.

This part has been modified from the original single DS Offset Snap (Part A) to fit into standard 32mm-spaced shelf pins with 5mm depth, making it ideal for integration into cabinetry setups without screws.