Shisha/Hookah tobacco press

I have a hookah with a phunnel from Kalifa (Kalifa Phunnel Steinkopf). I use it in combination with a lotus from Kaloud. When smoking, I always had the problem of the tobacco sticking to the underside of the lotus. As a result, the shisha tasted smoky. But I also want to avoid using aluminum foil.

That's why I designed a simple tobacco press with which I can press the tobacco on all sides to exactly the right height. 
Since then I can smoke the shisha to the end without any problems.

The press has spikes on the underside. These make it possible to move the tobacco slightly in the phunnel. I also wanted to ensure that the tobacco remains a little more airy at the same time.

I am aware that this is quite an individual setup. I have therefore attached my Fusion 360 file to the project. Please feel free to use this to customize the press to your setup.

Print:

Support required: Yes

Material: PLA