Skele-fun Bookmarks Set

If you want to sell prints of this model, as well as all of my models - future and past
Subscribe to My Patreon:

Or Subscribe for a commercial License Directly in Maker World:
 

Bring a bit of spooky fun to your reading time with these Skele-fun Bookmarks! Featuring cute ghosts, friendly skeletons, and playful pumpkins, this set is all about enjoying Halloween with a smile. Perfect for adding a touch of festive charm to your favorite books!

For best results use 0.2 nozzle if possible, but 0.4 is also works great (The pictures show a model printed with a 0.4 nozzle)
The design allows for printing with simple color changes at layer, which saves a lot of filament!

USE A LIGHTER! - a quick pass with a torch on the printed parts will get rid of the inevitable stringing that comes with this type of models.
 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Kingroon Black Transmission Distance: 0.4 / Amazon
PLA Prusa Gentleman's Grey Transmission Distance: 0.2 / Amazon
PLA KINGROON Red Transmission Distance: 4 / Amazon
PLA KINGROON Orange Transmission Distance: 4.5 / Amazon
PLA 3D Jake Eco White Transmission Distance: 2.5

Color Pallete:

Swap Instructions:

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Gentleman's Grey
At layer #10 (0.88mm) swap to Red
At layer #11 (0.96mm) swap to Orange
At layer #14 (1.2mm) swap to White for the rest.

How to do more than 4 colors on a single AMS?

To use more than 4 colors with a single AMS is pretty simple when it comes to HueForges.

Always start the print from either Bambu Studio or Bambu Handy App - This will allow you to map the rolls of filaments to a certain slot in the AMS:

Now map the first 4 colors (which should already be inserted in the AMS to Slots 1 - 2 - 3 - 4
Once thats done move to maping colors 5 - 6 - 7 - 8 to respectively AMS Slots 1 - 2 - 3 - 4 again!

This will allow you to Change the rolls of filament once the printer is done with that color.
For example, in the picture above once we are done with the Black color (Which is usually first) we are going to remove the black roll (you can do that while printing) with White, then once Charcoal Black is done we are going to change that to Red, Dark Gray to Yellow and we are done. ~ You can do that with as many colors as you need!
THERE IS A PAUSE ON THE LAST LAYER OF COLOR 4 TO AVOID HAVING TO BABYSIT THE PRINTER. ONCE PAUSED CHANGE 1-2-3 WITH 5-6-7 AND RESUME. IF YOU NEED MULTIPLE PAUSES YOU CAN DO THAT TOO.

Drop me a follow!🤜🤛