Search models, users, collections, and posts
D20 necklace
IP Report
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
10 min
1 plate
Open in Bambu Studio
Boost
45
103
2
1
28
8
Released
Description
You are a nerd who needs to carry a d20 all the time? This is your model.
Two pieces are held together with some scrap filament. If your print is not calibrated enough just use a screwdriver to enlarge the holes and voila!
I used generic PETG to print this model and filament gives enough flex that you can take out and place the d20 again and again. Very good for suprise random encounters.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (2)