Search models, users, collections, and posts
4x Build Plate Holder for MMSS
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.9 h
1 plate
Open in Bambu Studio
Boost
1
2
0
0
2
0
Released
Description
This was made after printing @Jorge Rui's MMSS found here. Taking a blank 2x6 block, I cut slots into the block that would fit a build plate that has 2 design sheets, one on each side, to accommodate the average max thickness of a build plate.
Each slot has an indentation on the bottom to align with the trapezoid notch on the build plates that the print head uses to wipe the nozzle.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)