Nano Skyhunter - APM Mini GPS Mounting Tray

This is a remix of Zapf's mounting tray for the Nano Skyhunter. It has been lengthened by 2mm and new mounting holes (32.5mm x 32.5mm center to center) have been created to allow mounting a APM mini GPS that uses the same mounting hole pattern.

I printed mine with 4 bottom and 4 top solid layers, 0.100 layer height, 10% infill and 2 perimeters.

Instructions:

1. Attach standoffs to the holes in the mount

2. Attached your flight controller or GPS to the standoffs

3. Slide out the existing wood tray from the Nano Skyhunter

4. Place the mount in at a slight angle press into the slots in the foam

5. Slide tray backwards into final position

Print Settings

Printer:

Raise3D N2

Rafts:

Supports:

No

Resolution:

Infill:

10-20%