Lucky Money Kitten

Lucky Cat_Ingot Kitten

• Exquisite and compact ornament, one-piece printing, equipped with three version configurations, namely
• Initial configuration outer contour size 40.8X38.5X50.6mm
• Only a small support is set on the cat's chest, initial configuration 0.2 enables variable layer height, it is recommended to print at 100% speed
• If the overhang quality is not ideal, pay attention to heat dissipation! Pay attention to flow calibration and drying of the consumables, you can get better printing quality!
• Wishing you all abundant wealth and good fortune, welcome everyone to print and support the picture, if you have any questions you can leave a message in the comment area for discussion
• Due to the excessive waste of consumables and time for multi-color printing, it is recommended to color manually, the following is basically a color reference

3D Printing Tips and Preparatory Precautions

(Most of the models released by creators have been tested and can adapt to all models, many times printing problems need to check whether your printer and consumables are normal, this is a skill you need to learn to play 3D printing, if you have any questions you can also actively discuss in the comment area, this is the meaning of building such a community)

Some precautions I have explained below, more questions can be asked to customer service or you can check Bamboo Wiki, you can learn a lot in itPrint Quality and Troubleshooting | Bambu Lab Wiki

• Make sure the printing plate is clean, it is recommended to clean the printing plate regularly! The grease residue on your hands after touching the printing panel will cause a great decrease in printing adhesion, and the small debris from previous printing and the small remnants of printed objects will also affect the printing quality of the first layer, thereby reducing the yield.
• Pay attention to the drying of consumables, this will greatly affect your printing quality and printing experience! Consumables will inevitably become damp after being placed for a long time, if there is stringing, it is recommended to ask the manufacturer for the drying parameters to dry the consumables, at the same time most manufacturers' consumables are not dried when they leave the factory, so our newly opened consumables are still a little damp, and it is also recommended to dry them before use.
• Use new manufacturer's consumables and it is recommended to start printing first-time consumables flow calibration, and modify the calibration coefficient, this will greatly affect your printing quality, and is also a necessary process for making new consumables adapt to your printer.
• If you encounter a problem that the printing suddenly becomes poor quality and the yield is low, check whether the nozzle is clogged, and you can also try recalibrating the printer.
• Print at the recommended print speed in the model instructions. Overhang quality is directly related to print speed, the right speed (too fast or too slow is not good) can allow the material to have more time to cool and form when it is deposited.
• Set the hot bed and nozzle temperature reasonably according to different materials. Temperatures that are too high or too low will cause warping, layered distortion, or adhesion problems, thereby affecting the printing quality and success rate.