DJI RC N2 N3 Remote Controller Tablet Holder

First, I want to thank the creator of “且听风吟” for the idea. Initially, I also printed and used his model, and it worked quite well. However, perhaps his tablet was smaller or the controller handle was different, as installing and removing my iPad Air was somewhat difficult. Therefore, I made some modifications based on his design. The stand was slightly lengthened and also hollowed out. Currently, the stand I designed has been updated with several different lengths, which should better match tablets of various widths. Relevant RC-N3 users have also tested it, and it seems to be usable.

It is recommended to add a silicone anti-slip pad where the tablet is clamped. A 2mm thick anti-slip pad with adhesive backing works very well, and the tablet will be difficult to dislodge once installed. The silicone anti-slip pad I used was 20mm*2mm, which I cut and adhered myself.

First of all, I would like to thank the creator of “且听风吟” for providing the idea. At first, I also printed his model for use, and the working effect was quite good. However, perhaps his tablet was a bit small or the handle was different, and it was a bit difficult to install and remove my iPad Air. Therefore, I made some changes based on his model. The stand was slightly lengthened, and at the same time, a hollowed-out treatment was done. At present, the stand I designed has been updated to several different lengths. It should be able to better match tablets of different widths. Relevant users of RC-N3 have also conducted tests, and it seems to be usable as well.

It is recommended to add a silicone anti-slip pad at the position where the plate is clamped. A 2mm thick anti-slip pad with adhesive backing is very useful and will be difficult to loosen after the plate is installed. The silicone anti-slip pad I used is 20mm*2mm. I cut it myself and stuck it on.