Subaru Forester MagSafe charger mount

I made this for my 2019 Subaru Forester. It drops into the space just behind the cup holders and fits snug enough that it doesn't rattle around, quite snug. I made the hole for the charger 0.15mm smaller than the charger measured and that was just right. The charger needs a little force to press it into place and feels quite snug. I made a hole that goes through the back in case you want to push the charger back out for any reason. This was designed to fit best after removing the little rubber mat that sits at the bottom of the space this goes into. 

In the photo, that is an iPhone 15 Pro Max. The larger cup is a 40 ounce Stanley, the smaller is an 18 ounce Yeti. The Stanley just barely touches, but you can twist the phone just a bit on the mount and it's stable/stays in place.

In the event that you want to print this and buy the same charger as me (others may be different sizes?), it came from Amazon and the description is “JSAUX Magnetic Wireless Charger Compatible with MagSafe…” I couldn't figure out how to answer yes to “does your model require non-3D printed parts?” and then list the charger.