Search models, users, collections, and posts
Pocket T Ruler, Square, Marking Gauge 10cm
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 25% infill
Designer
48 min
1 plate
Manual Colour Change
Designer
46 min
1 plate
Open in Bambu Studio
Boost
385
1014
85
23
907
574
Released
Bill of Materials
Description
Handy little tool for makers, to put in in your front apron pocket.
Pocket T ruler measures 10cm in length in 1mm increments.
According to my trusted precision ruler, it is very accurate.
Use 0.7 - 0.9mm pencil lead. I use 0.9mm and works great. My favourite pencil is Pentel Grapher 1000
Colour change is on third layer, no prime tower, I did not have any issues with colour bleeding, but if you want you can enable prime tower.
I will add manual colour change print profile with pause.
Happy printing.
- All photos uploaded are of the actual printed model, and are copyright protected
- If you enjoy this model please consider to buy me a coffee
- Commercial licence membership available through the link below or on my Patreon
Membership
With a Commercial License Membership, you gain the right to sell 3D prints made from my designs.
Join
License
If you want to use this model commercially, please join my membership.
Join Now
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (85)