Search models, users, collections, and posts
Beltmate 2GT W6L5
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
2.4 h
1 plate
Open in Bambu Studio
Boost
3
2
2
1
14
1
Released
Description
Require
- Heat set insert same as VORON spec (M3x4x5)
- Counter sunk screw laying around your floor
No support needed.
Feedback is welcome!! Once I gather some amount of feedback, I'll post 10mm version.
Material: I don't recommend center parts with PLA. ABS, PC or PC-ABS worked good so far.
Even without center cap, it works.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)