Stay Puft Gang (after)life-sized

These are the show-stealing little marshmallows from the last two Ghost Busters movies.

I don't take credit for the original files. Those were made by @ghostprint84 over on Printables who graciously made them available for public use.

I just combined the three different files into a profile and added the color for AMS printing.

The higher quality settings utilize variable height layers and will do wonders for preventing banding on the hats and around the shoulders but that, combined with the color, does add to the print time. If you have more than 1 AMS and can do five materials at a time, I HIGHLY recommend using PTEG or some other support interface material to make clean support removal easy.

The profile is set up that way but if you don't have it, you can remove the fifth material.

Also going to upload a faster file. Depending on your use, you may need to sand a few surfaces for that.

For the ribbon, I'm using cut red tape but any ribbon or even colored paper will do.

I toyed with adding this into the slicer but it created a really weak shape and didn't look as good.