Search models, users, collections, and posts
Din Rail Breadboard Mounts
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.2 h
2 plates
Open in Bambu Studio
Boost
19
85
0
0
72
30
Released
Description
These are din rail breadboard mounts for 400 and 830 points breadboards. The
din rail clips can be attached temporarily to the breadboard base using a
piece of 1.75 mm filament. The clips can be attached horizontally or
vertically to the breadboard base. They can also be glued to the breadboard
base for a permanent setup. Clips shall be printed on their side. The 830
points Breadboard base needs two clips.
Support material is not required. An infill of 20% is recommended.
This object main web page is:
http://www.ctheroux.com/din-rail-breadboard-mounts/.
This object was designed using Solid Edge Community Edition.
You can request the source files on the page listed above.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)