Search models, users, collections, and posts
Sunlu Spool Adapter for AMS
IP Report
Print Profile(1)
0.24mm layer, 2 walls, 12% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
143
314
164
22
1.4 k
822
Released
Description
An adapter for the Sunlu brand of filament – the spools as-is are too loose for the AMS, so this adapter will allow it to be used for multicolor prints. It should stay in just fine without glue, so you can reuse them when you finish up your spool!
Want to sell prints of my designs? Check out the commercial license on my Patreon!
Boost Me (for free)
If you like this design, please consider giving me a boost! It helps out a lot :)))
Designer's Note: No AI was used at any point in the creation of this file. All design work was done manually, and images have not been enhanced by AI.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (164)