Hueforge model of mars

This is a Hueforge model of mars. I took a high resolution picture of Mars from NASA. Removed the background using this site: https://www.img2go.com/ and then used the hueforge settings attached (and below). 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 240x240mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA PolyLite Black Transmission Distance: 0.3
    PLA+ Esun Orange Transmission Distance: 5
    PLA Overture Yellow Transmission Distance: 9.7
    PLA+ Numakers Pure White Transmission Distance: 4.8
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #11 (0.96mm) swap to Orange
    At layer #15 (1.28mm) swap to Yellow
    At layer #20 (1.68mm) swap to Pure White for the rest.