Satisfactory Object Scanner

Object Scanner from Satisfactory. Included the whole Model if anyone wanted to print it in one go or would like to see how the model looks like whole. Not sure how it would print in on go though. Since I prinetd this on a A1 mini I cut the 2 side antennas and the small antenna on top off, and printed them seperately. I used super glue to then attatch them back on and had no problems doing it that way. Looking at the plate with the main body it does look like the screen is missing but when sliced and prinetd the screen while appear and fill that area the same goes with the little area where the knob is supoosed to go that is why the knob is cut in half so all you have to do is glue it onto that little area and it should fit in perfectly. Also note that the full model I included with all antennas and features on already is scaled down and is not the same scale as the one where you have to glue peices onto it.

BTW: the print time says its around 11 hours but that is just because of the full model I included which you do not have to print, actual print time is around 7 hours and thats mostly for the main body.

If anyone has any questions or comments please let me know by leaving a comment or messaging me. Hope you all enjoy this print! :)

BTW: I did not make this model, I used Fmodel to get the mesh files then used blender to convert them into .stl Files. Can be scaled up or down and there shouldnt be to many problems.