Raptor 3 Engine (CrazyJ) Real Hardware Remix

This is a real hardware remix for CrazyJ's Raptor 3 Rocket Engine Model.

The parts remixed so far include:

Upper Engine (1)

Upper Engine (2)

REQUIRED OR SUGGESTED HARDWARE:

Taps: 1.8mm and 2mm Tap

Grub Screws: 35 - 2x4mm

Screws: 12 - 3x10mm

Nuts: 12 - 3mm (choose your favorite, Nylon Insert lock nuts may be visually more appealing)

For Upper Engine (1) -

The part that will use the 35 grub screws- I suggest running a 1.8mm tap through the bottom of every hole. Then, run the 2mm tap afterward. Be patient, be careful. These walls are thin, and if you try to skip steps or force something the walls will more than likely snap.

For Upper Engine (2) -

-This one is self explanatory. Get creative: Use whatever color bolts/screws/nuts you like. You can use regular nuts like I did (just used these because I have a ton laying around) - Or you can opt for a better looking nut: Perhaps a Nylon Insert lock nut.