Monoprice Mini Delta (V2) LED Ring light Mount

I designed this to improve the lighting in my Monoprice Mini Delta V2. This makes a huge difference and QOL to this little printer without adding LEDs and unnecessary weight to the printhead.

If the handle design is the same in the V1 then it should also work with that, no issues.

Designed to work with 70mm 12V automotive ring LED lights. Take note of the 3 small prongs/clips at the back, they should match what I have pictured.

The little LED circuit board case should be removed and heat-shrink applied in order to reduce its footprint.

You will need to run the power wires down to the base to a 12v (ideally switched or install a sepweate switch) supply.

Updated with a couple of pics of it illuminated. Motion system is disconnected, however, due to upgrades ;)