Search models, users, collections, and posts
Airbi Smile sensor holder
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
33 min
1 plate
Open in Bambu Studio
Boost
0
0
0
0
2
1
Released
Description
I use it in my drybox.
Link on sensor:
https://www.airbi.cz/en/thermometer-hygrometer-smile
NO SUPPORTS
Use M3 screws
Tip:
When you mount the holder, insert the sensor into the holder. Subsequently, when you mark the holes for drilling, press the holder so that the sensor is not too loose in it. The sensor could fall out of it later.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)