Mech Carrot Knife

Mech style designed carrot knife, the blade slider needs to be supported, other prints can be printed without support, for safety, large pieces need to be printed with a skirt, the design adds a push card design, the blade is pressed and retracted to play

Installation steps:

1. Install the slider first, fix the cover with glue, the slider needs to be treated with a small knife to bond, then fixed with glue, but dry the thickness to install the corresponding magnet size

2. Install the flip cover magnet, the same 10*3 specification magnet

3. Install the blade rubber band, use a paper clip to fix the rubber band, one end is fixed in the middle of the slider with an M2.5*6 countersunk screw, and the other end is fixed with consumables or toothpicks

4. Install the blade, fix it with M2.5*18 and a printed nut, after fixing, cover the hardware with a cap

5. Install the flip cover, fix it with M3*25, adjust it and try the tightness, tighten the cover after it is suitable

6. Install the slider, complete the whole