Search models, users, collections, and posts
Dummy 13 - Improved Kasa Hat Accessory
Remixed by
IP Report
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
17 min
1 plate
Scale for 150% DUMMY - 0.16mm layer, 2 walls, 15% infill
47 min
1 plate
Open in Bambu Studio
Boost
2165
5536
366
144
7.4 k
4.3 k
Released
Description
Based on a design by Colorado Science. I found the original a little difficult to print and a bit loose fitting. Redesigned from the ground up.
Reshaped the slot (using the official hat accessory as a base) to better fit the dummy's head, and adjusted the model so that the brim of the hat prints flat on the build plate, limiting the need for supports. Other than that all dimensions are the same or similar to the original. 3mf file set up for fuzzy skin with a modifier to prevent the inner walls being printed fuzzy to maintain a good fit. Overall it should print easier and fit better.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (366)